| 01. |
GENERAL REQUIREMENTS (Content Area) |
10% |
| |
0101.
Project Administration and Legal (Task) 3%
Verify that required permits are issued and valid.
Issue and maintains inspection reports, correction
notices, stop work orders and data for the issuance
of the certificate of occupancy. Verify that the
required approved plans and specifications are available
on the job site. (Some questions may refer to a
set of plans for reading fixture schedules, panel
schedules, riser diagrams, etc.) |
|
| |
0102.
Public Information (Task) 2%
Communicate the intent of the code using proper
terminology. Answer questions about general code
compliance, procedures and materials. Identify the
suitability of the installation of materials according
to the listing, and labeling. |
|
| |
0103. Conductors (Task) 5%
Inspect conductors to verify correct use and installation,
type, insulations, markings, and ampacity. Verify
that conductor connections, splices and terminal
identification meet code requirements. |
|
| 02. |
SERVICES
(Content Area) |
17% |
| |
0201.
Service Size, Rating and Installations (Task) 8%
Inspect services to verify, required conductor ampacity,
clearances, location, materials, equipment and provisions
for installation. |
|
| |
0202. Service and Feeder Grounding and Bonding
(Task) 9%
Verify size, type of conductors and electrodes
including location and installation. |
|
| 03. |
BRANCH
CIRCUIT & FEEDER REQUIREMENTS (Content Area) |
19% |
| |
0301.
Branch Circuit and Feeder Installation (Task) 5%
Inspect branch circuit and feeder installation to
verify conductor size, clearances, location, materials
and equipment grounding conductors. |
|
| |
0302.
Branch Circuit and Feeder Calculations (Task) 4%
Verify that the load to be placed on branch circuits
and feeders meets code provisions for the conductor,
devices, materials and equipment installed. |
|
| |
0303.
Branch Circuit Ratings and Overcurrent Protection
(Task) 5%
Verify correct size, type, location and installation
of overcurrent devices. |
|
| |
0304. Equipment Grounding and Bonding (Task)
5%
Verify correct size, type, location and installation
requirements for equipment grounding. |
|
| 04. |
WIRING
METHODS AND DISTRIBUTION SYSTEMS (Content Area) |
19% |
| |
0401.
Branch Circuit Required Outlets (Task) 3%
Verify that receptacle and lighting outlets and
switches are provided in all required locations.
Verify that ground-fault circuit interrupter protection
is provided in all required locations. |
|
| |
0402.
Boxes, Enclosures and Conduit Bodies (Task) 5%
Verify that boxes, enclosures and conduit bodies
are proper type, correctly sized and installed. |
|
| |
0403.
Panelboards and Switchboards (Task) 6%
Verify location, clearances, rating, circuit identification
and overcurrent protection. |
|
| |
0404.
Raceways, Cables and Bus Ducts (Task) 3%
Inspect conduit raceways, wireways, busways, and
cablebus to verify correct use, type, size, support,
and installation. Inspect sheathed cable, armored
cable, metal-clad cable, to verify correct use,
type, support and installation. |
|
| |
0405. Flexible Cords and Fixture Wires (Task)
2%
Verify proper use and sizing of flexible cords. |
|
| 05. |
GENERAL
USE EQUIPMENT (Content Area) |
12% |
| |
0501.
Switches, Receptacles and Light Fixtures (Task)
3%
Verify that light fixtures and fixture wires are
of correct type, and rating and are properly installed
Verify that switches and receptacles are of the
correct type, rating, and are installed properly. |
|
| |
0502.
General Use Equipment and Other Appliances (Task)
3%
Inspect general use equipment, space heating and
cooling equipment including air conditioning and
refrigeration wiring and equipment to verify correct
type, use, installation and disconnecting means.
Inspect appliance wiring and equipment to verify
correct type, use, installation and disconnecting
means. |
|
| |
0503.
Motors and Controllers (Task) 3%
Inspect motors and phase converters to verify correct
use, size, voltage, and type, and inspect motor
control circuits to verify correct size, motor protection
when required, and wiring. |
|
| |
0504. Transformers, Generators and Miscellaneous
Equipment (Task) 3%
Inspect other general use equipment and wiring,
including capacitors, resistors, and batteries,
to verify correct type, use, and installation.
Inspect generators and transformers to verify
correct use, size, type and installation. |
|
| 06. |
SPECIAL
OCCUPANCIES (Content Area) |
9% |
| |
0601.
Hazardous Locations (Task) 3%
Inspect materials and equipment required specifically
for use in hazardous locations to verify suitability
for the intended use, and verify that work has correct
installation and sealing. |
|
| |
0602.
Health Care Facilities (Task) 2%
Inspect electrical installations in health care
facilities to verify compliance with special code
requirements. |
|
| |
0603.
Miscellaneous Other Special Occupancies (Task) 1%
Inspect the electrical installations of other special
occupancies to verify compliance with special code
requirements. |
|
| |
0604. Commercial Garages, Gas Stations &
Bulk Stations (Task) 3%
Verify correct type of wring methods and materials
for commercial garages, gas stations, and bulk
stations and similar hazardous locations. |
|
| 07. |
SPECIAL
EQUIPMENT (Content Area) |
7% |
| |
0701.
Swimming Pools, Fountains and Similar Installations
(Task) 4%
Inspect electric wiring and equipment installed
for swimming pools, spas, indoor installations of
decorative fountains and similar installations to
verify correct type, use, bonding and installation
of electrical materials. |
|
| |
0702. Miscellaneous Special Equipment (Task)
3%
Inspect electric wiring and equipment for miscellaneous
special equipment to verify correct type, use,
and installation. Verify correct wiring for computer
and data equipment. Inspect electric wiring and
equipment installed for electric signs to verify
correct type, use, and installation. |
|
| 08. |
SPECIAL
SYSTEMS (Content Area) |
7% |
| |
0801.
Emergency Systems (Task) 2%
Inspect emergency system wiring including legally
required and optional standby systems. |
|
| |
0802.
Signaling Systems (Task) 2%
Inspect low voltage control wiring, Class 1, 2,
and 3 circuits, and fire protective signaling circuits. |
|
| |
0803.
Fire Alarm Systems (Task) 2%
Inspect Fire Alarm systems for correct use, wire
size, type and installation and operation. Verify
correct location, number and wiring of fire alarm
system devices. |
|
| |
0804. Communications Systems (Task) 1%
Verify proper type and location of wire installed
for communication circuits, including CATV and
fiber optics. Verify proper clearances and grounding
of conductors for communications systems. |
|
