ICC logo masthead graphic masthead graphic
 
masthead graphic
MembershipProduct StoreCodes & StandardsGovernment RelationsTrainingCertification and TestingConsumer SafetyJobs and Code TalkNewsroom and Events

Inspector  |  Contractor  |  Renewals  |  UST / AST Certification  |  Legacy / State



Certification: Vapor Recovery System Installation and Repair

Exam ID: VI
 
  • 60 multiple-choice questions
  • 1½-hour limit
  • Open book
Sample Examination Questions: The sample questions are provided to give you an idea of the style and format of examination questions. The questions are not intended to represent content, references or questions that will be on the examination. They are not intended nor should they be referenced/used as a study tool for the examination.
1. Compounds with a high vapor pressure, such as gasoline, will evaporate readily and will typically: Click for Answer
    A. be difficult to ignite.
    B. have a low flash point.
    C. be used for heating oils.
    D. have a high ignition temperature.
2. The minimum sloping of the underground vapor recovery piping from the dispensers to the underground tanks is _____ inch per foot. Click for Answer
    A. 1/8
    B. 1/4
    C. 1/2
    D. 3/4
3. The best time to verify with local agencies that vapor recovery equipment meets all applicable requirements is: Click for Answer
    A. during the installation.
    B. before beginning the installation.
    C. 30 days after completing the installation.
    D. the day before the station opens for business.
4. According to Executive Order VR-201-A, if the product dispensing flow rate is below 6.5 gpm, the repair person should: Click for Answer
    A. install a flow limiter.
    B. replace the dispenser filter.
    C. replace the nozzle and hose combination.
    D. check the Clean Air Separator for proper operation.
5. According to Executive Order VR-201-A, quad seals are used on the end of the hose that attaches to the: Click for Answer
    A. nozzle only.
    B. nozzle and dispenser outlet.
    C. breakaway (or flow limiter if equipped).
    D. nozzle and nozzle side of the breakaway.

Return to certification category


 

Contact Information

1-888-ICC-SAFE (422-7233), ext.
Certification Examinations
33806
Certification Renewal
33815
MCP Certification Examinations
33806
CBO Examinations
33806
Contractor Examinations
33805
Legacy Examinations
33823
UST/AST Examinations
33823
Special Inspection Examinations
33823



Click for more information

 

 
Home | Membership | ICC Store | Codes & Standards | Government Relations
Training | Certification & Testing | Public Safety | Jobs & Code Talk | Newsroom & Magazine
Contact Us | Privacy Policy
Subsidiaries: ICC Evaluation Service | International Accreditation Service | ICC Foundation
© 2008 International Code Council

 

About ICC ICC Board Site Map Contact Us Help